Filter
Top Products
104
INSTALLATION MENU
ADVANCED CHANNEL SEARCH
Frequency:
Use the numeric keypad to input the frequency on which the channel being searched for should be
transmitted.
Symbol:
Use the numeric keypad to input the symbol rate.
QAM mode:
Use the
buttons to select the correct type of modulation (16, 32, 64, 128 or 256 QAM).
Network Search:
Use the
buttons to select the setting for the network search.
If you set the network scan to “On”, the networking of the transmission channels enables additional
transmission channels that have not yet been saved to be located. They are then saved and searched for
new channels in the same way as the existing channels.
If you set the network search to “Off”, only the frequency you selected will be searched.
Select FTA and/or CI:
Use the
buttons to select whether you want to search through all channels or only FTA (Free to Air)
or CI (= Common Interface - encrypted channels).
Start Search:
When you have made your selection, use the
buttons to select “Start Search” and press
the
button to start the search.
The on-screen displays during and after the end of the search are the same as for the “Automatic Search”.
See “Software and Programme List Update” section
UPDATE OPERATING SOFTWARE