Filter
Top Products
9
Important note on setting up receiver on a UFO
®
micro
system
When registering the receiver to a UFO
®
micro single-cable
matrix EXU 544, you must do the following:
- Connect the receiver to the TV set, but do not yet connect
it to the ESU 32 antenna socket.
- Perform a UFO
®
micro reset on the receiver as described
below.
1. Press the
button to switch to the main menu.
2. Press the
buttons to get to the installation menu and
confi rm your entry by pressing
.
3. Press the
buttons to get to the DiSEqC™ menu and
confi rm your entry by pressing
.
4. Press the
buttons to select the “UFO” option.
5. In the UFO menu press the
buttons to select
“UFO
®
micro”.
6. Press
and change the selection to RESET with the
buttons, then confi rm your entry by pressing
.
7. Press
to exit the UFO menu (press
to confi rm the
changes).
8. Press
three times to get back to the starting point.
- Press the
button to switch the receiver to standby
mode.
- Now you can connect the receiver to the antenna
socket.
- Press the
button to switch the receiver on.
- The registration is then performed automatically – the
screen briefl y shows: “UFO
®
micro active”.