Filter
Top Products
21
Using Receiver
How Do I Adjust the Surround Modes?
Checking the Input signal during playback
During playback of Dolby Digital, MPEG or DTS signal, the surround
identification signal in the input is identified and displayed by means of
the L, C, R, SR, SB (or S), SL and LFE icons.
1. Press the F.SHIFT = 10 (STATUS)* button on Remote Control unit.
After 8 seconds, the display goes off.
Input Status
Dolby
Digital
F.Auto
* When an operation is described as [F.SHIFT = 10 (STATUS) button],
for example, press the F.SHIFT button and press the next button (the 10
(STATUS) button in this case) within 8 seconds.
123
456
789
10 11 12
+10 0 +100
/8
/7
1
1
LCR
SL
LFE
SB
or
S
SR
L : left channel
C : center channel
R : right channel
SL : left surround channel
SR : right surround channel
SB : left and right surround back channel
S : surround channel
LFE : low frequency effect channel
■ : identified signal
Example:
5.1 ch encoded Dolby Digital 2 ch Dolby Digital