Kenwood VR-5080 DVR User Manual


 
23
Using Receiver
How Do I Adjust the Surround Modes?
* When an operation is described as [F.SHIFT = LISTEN M. (INPUT
MODE) button], for example, press the F.SHIFT button and press the
next button (the LISTEN M. (INPUT MODE) button in this case) within
8 seconds.
Switching Input Modes
To fully enjoy the sonic benefits of specially-encoded DVD AUDIO discs
played on a compatible DVD player, you must set the receivers input to
6Ch Input.
When you are finished listening to analog media, set the receivers input
back to Full Auto.
1. Press the F.SHIFT = LISTEN M. (INPUT MODE)* button on Re-
mote Control unit.
2. Repeat step 1 until the desired input mode is displayed.
Operation on the receiver:
1. Press the INPUT MODE button inside the door repeatedly until FULL
AUTO, DIGITAL MANUAL, ANALOG or 6CH INPUT is displayed.
If you turn off the receiver, select a different source device, the Digi-
tal manual is reset to Full Auto.
When you use Full Auto mode with certain DVD and LD players,
performing operations such as Skip or Stop may momentarily
interrupt the output.
123
456
789
10 11 12
+10 0 +100
/8
/7
1
1
Input Status
Dolby
Digital
F.Auto