Filter
Top Products
75
Troubleshooting
• Check that the correct video input on the TV is selected.
• Check that the video software you record does not have copy guard
protection.
• All Zone B inputs must be composite. S-Video is not supported in
Zone B.
Remote Control unit
My Remote Control unit is slow to respond—sometimes I have to
press buttons or select commands several times
• If Remote Control unit is in sleep mode (the screen is blank), the first
button press “wakes it up”. The second press performs the action.
• Your Remote Control unit supports 2-way communication with the
receiver. If the 2-way communication indicator on the front of the
receiver is lit, Remote Control unit is receiving information. It cannot
transmit your new command until it is finished receiving informa-
tion from the receiver.
My Remote Control unit is not responding
• Make sure you are within the operating range for Remote Control
unit. See “Remote controllable range” on page 7 of this manual.
• Replace the batteries. See Chapter Two of the Connections and Setup
Guide.
• If you’re using an IR receiver, make sure it is connected properly and
turned on. See Chapter four of the Connections and Setup Guide.
• Check the contrast of the LCD display is adjusted properly. See “How
Do I Adjust the LCD Display” on page 50.
• When the RF ON/OFF (INPUT MODE) button is pressed for 2 sec-
onds or longer, “RF OFF” will be displayed. In this condition, the
main unit can not receive remote control signals. Press the RF ON/
OFF (INPUT MODE) button again for at least 2 seconds to display
"RF ON". See page 49 of the Connections and Setup Guide.
• If you want to use Remote Control unit by setting the control mode
to Zone B, make sure that the Multi-Zone function is On. If this func-
tion is Off, you cannot control Zone B from Remote Control unit.
Video/Remote Control unit