Kenwood VR-5080 DVR User Manual


 
72
Moving Around
Troubleshooting
Sound
I cant hear sound from one or more of the speakers, or the sound
is abnormally low
Check that:
All of the speaker wires are connected tightly, not short circuited. See
Chapter One of the Connections and Setup Guide.
All of the speakers have been activated in the Setup Speakers menu.
See Chapter Two of the Connections and Setup Guide.
The individual speaker levels are set properly. See Chapter Two of the
Connections and Setup Guide.
The CD2/TAPE2 MONITOR input has not been selected. (If it has,
the CD2/TAPE2 MONITOR monitor indicator on the receivers front
panel will be lit). See Whats on the Front Panel of Your Kenwood
Audio - Video Receiver? on page 2 of this manual.
The correct speakers have been activated. See Turning the Speakers
On on page 9 of this manual.
The correct listen mode has been selected. See What are Listen
Modes? on page 18 of this manual.
I cant hear sound from my surround or center speakers
Check that:
The proper surround play mode (Dolby Pro Logic, Dolby Pro Logic
II, DSP, MPEG, DTS NEO:6, DTS, DTS-ES or Dolby Digital) has been
selected. See What are Listen Modes? on page 18 of this manual.
All of the speaker wires are connected tightly. See Chapter One of the
Connections and Setup Guide.
I can hear sound only from the center speaker when Dolby Pro
Logic is selected
Check that the program (e.g., TV show, radio station, VCR tape) is in
stereo. Programs in mono play only through the center speaker when the
receiver is in the Dolby Pro Logic listen mode.
A DTS-ES encoded source is played but it is not decoded in DTS-ES.
DTS-ES decoding in playback is not available if THX is set to THX
Surround EX On, THX Surround EX Auto or THX is On. Set THX to
Off. See To set the THX Mode on page 24 of this manual.