Filter
Top Products
Disconnect the cable on your cable, satellite or HD set-top box that is
connected to your TV (you need to connect 1 video and 1 audio).
Connect the VIDEO—look at the options available on the set-top box
and choose 2A or 2B.
To maintain best picture quality—if the back of the set-top box
has any COMPONENT VIDEO (Y, P
B, PR) OUTPUT jacks, plug
corresponding cable(s) into the jack(s) on the set-top box and to
the Klipsch CS700’
S SAT/CBL/HD INPUT COMPONENT
jacks (Y to Y; P
B to PB, PR to PR). If you use 2A, you must
also connect the corresponding output from the Klipsch controller’s
“VIDEO OUTPUT” section to your TV to ensure that you get a picture.
These cables have not been included with the Klipsch system.
When using the HDMI connection you must turn Progressive Scan
(P. SCAN) “On”. If the HDMI connection are used and P. SCAN
is “Off”, you will not see a picture.
If the set-top box has a VIDEO (yellow)
OUTPUT
jack for video, plug
the supplied yellow video cable into that jack and to the Klipsch
system’s
SAT/CABLE/HD INPUT COMPOSITE
(yellow) jack.
1.
2.
CABLE IN
O U T P U T S
VIDEO S-VIDEO
COMPONENT
Y PB PR
CABLE BOX (shown)
DIGITAL
COAXIAL OPTICAL
AUDIO
L R
CABLE SIGNAL
- OR
-
- OR -
- OR -
2A
2B
3C
3B
3A
HDMI OUT
KLIPSCH CONTROLLER
STEP 3A: Set-Top Box Connection
Connect the AUDIO—look at the options available on the set-top box
and choose 3A, 3B, 3C.
Connect the supplied audio cables to the AUDIO LEFT (white) and
AUDIO R
IGHT
(red) jacks on the back of the set-top box and to the
Klipsch system’s
SAT/CABLE/HD INPUT LEFT
(white) and
RIGHT
(red) jacks.
If the set-top box has Digital AUDIO (
COAXIAL
), connect appropri-
ate cable to the set-top box AUDIO COAXIAL jack and to the
SAT/CABLE/HD INPUT COAXIAL
jack.
If the set-top box has Digital AUDIO (
OPTICAL
), connect appropriate
cable (not supplied) to the Klipsch System’s
SAT/CABLE/HD INPUT
OPTICAL
jack. You will first need to remove the plastic dust plug.
Note: If you connect a high definition Y, P
B
, P
R
INPUT, you must also
connect the corresponding Y, P
B
, P
R
OUTPUT to your TV. If you connect
HDMI, you must also connect the corresponding output from the Klipsch
controller’s “VIDEO OUTPUT” section to your TV to ensure that you get a
picture. These cables have not been included with the Klipsch system.
3.
A.
B.
C.
Use this connection if your TV has a cable box, satellite receiver or HD receiver set-top box connected to it.
See next page (3B) if no set-top box is used.
A.
B.
Please see appendix I (page 28) for the basics on how input
and output jacks work with your Klipsch system.
Input and Output Jacks