Filter
Top Products
2-6
A Guide to TracVision R5/R4
12. Cut the tie-wraps holding the antenna unit to the
forward shipping r
estraint (see Figur
e 2-7).
Figure 2-7
Forward Shipping Restraint
Figure 2-6
Baseplate Connectors Facing
Front of Vehicle – Recommended
Drain Hole Locations
You MUST drill out the drain holes
as indicated to ensure that any
moisture that enters the baseplate
is able to drain. Ensure that factory-
drilled holes are completely sealed.
11a.(Alternate Drain Hole Locations) If the antenna unit
is installed with the connectors facing the front of
the vehicle, drill out
3
⁄16" (5 mm)-drain holes in the
rear-facing side of the baseplate as illustrated in
Figure 2-6. The existing factory-drilled drain
holes shown in Figure 2-5 must then be plugged
with silicone rubber sealant.
Factory-drilled
Drain Hole Positions
Front of
Vehicle
Recommended
3/16" (5 mm)
D
rain Hole Positions
Drain Hole Angle
(
relative to baseplate)
Front of
V
ehicle
Angle of Hole, relative to front
Angle of Hole, relative to front