Filter
Top Products
39
Leica CM 3050 S – Cryostat
5. Operation
Press this key to alternate between the
two functions.
illuminated:
Trimming mode is active
off:
Sectioning mode is active.
Selecting trimming thickness
• Activate trimming mode
• Select trimming thickness (= sectioning
thickness at which trimming is carried out)
by pressing
or .
The selected thickness is displayed in the cor-
responding LED
:
Motorized trimming
• Select ‘Continuous stroke’ in functional area
A.
• Activate trimming by pressing RUN/STOP
and RUN/ENABLE (located in functional
area C) simultaneously or by depressing the
footswitch.
• To stop trimming press RUN/STOP or RUN/
ENABLE or depress the footswitch again.
Trimming thickness can be changed while trim-
ming is in motion by pressing
or .
5.4.7 Setting the section thickness
• Activate sectioning mode ( off).
• Press
or to select section thickness.
Pressing one of these keys once makes the
display in control panel 1 switch to section
thickness indication (thickness value not yet
being altered). Pressing
or further
starts to change the actual section thick-
ness setting.
Selectable section thickness settings:
0 - 2 μm in 0.5-μm steps,
2 - 10 μm in 1-μm steps,
10 - 20 μm in 2-μm steps,
20 - 60 μm in 5-μm steps,
60 - 100 μm in 10-μm steps,
100 - 300 μm in 50-μm steps.
5.4.6 Trimming and sectioning functions
Functional area B - all models
Switching between trimming
and sectioning
CT....°C OT....°C
μ010.0