Filter
Top Products
14
AUDIO/VIDEO CONNECTION
1. Connect the VIDEO OUT jack on the Home
Theater System to the video in jack on the TV
using the video cable (V).
2. Connect the Left and Right AUDIO OUT jacks from
the Home Theater System to the audio left/right in
jacks from the TV using the audio cables (A).
S-VIDEO CONNECTION
Connect the S-VIDEO OUT jack on the Home Theater
System to the S-Video in jack on the TV using the
S-Video cable (S).
Notes:
• For VIDEO OUT and S-VIDEO OUT jack
connection, resolution must be set to 480i or 480p
by pressing RESOLUTION on the remote control,
however VIDEO OUT and S-VIDEO OUT is always
at 480i standard resolution.
• HDMI mode must be set to OFF for VIDEO OUT
and S-VIDEO OUT jack connection.
COMPONENT VIDEO (Color Stream
®
)
CONNECTION
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the Home Theater System to
the corresponding in jacks on the TV using an Y Pb Pr
cable (C).
PROGRESSIVE SCAN (ColorStream® pro)
CONNECTION
If your television is a high-definition or “digital
ready” television, you may take advantage of the
Combi Receiver’s progressive scan output for the
highest video resolution possible.
If your TV does not accept the Progressive Scan
format, the picture will appear scrambled if you try
Progressive Scan on the Home Theater System.
Notes:
•You can change the resolution (480i, 480p, 720p,
1080i) for the component/progressive scan video
output by pressing RESOLUTION on the remote
control.
• For 720p and 1080i resolution, only non-copy
protected discs can be played back. If the disc is
copy protected, it will be displayed at the 480p
resolution.
• HDMI mode must be set to OFF for Component
video connections.
•Progressive scan does not work with the analog
video connections (VIDEO OUT & S-VIDEO).
ANTENNA
INPUT
L
R
Y
Pb
Pr
COMPONENT/PROGRESSIVE VIDEO INPUT
AUDIO INPUT
VIDEO
INPUT
S-VIDEO
INPUT
R
Rear of TV
S
A
V C
Rear of Home Theater System
Connecting to a TV
Make one of the following connections, depending on the capabilities of your existing equipment.
RF COAXIAL CONNECTION
Connect the RF.OUT jack on the Home Theater System to the antenna in jack on the TV using the 75-ohm
Coaxial Cable supplied (R).
Note:
If you use this connection, tune the TV to the Home Theater System’s RF output channel (CH 3 or 4).
How to set the Home Theater System’s RF output channel
When the
Home Theater System
is turned off,
press and hold TRK/PRESET(-/+) (v or V) on the remote control
for about five seconds to change the RF output channel (CH 03 or CH 04). “RF-03” or “RF-04” appears in the
display window.