Filter
Top Products
18
8. Attach the hard disk mounting brackets with the
screws.
9. Connect the power cable.
10. Connect the IDE cable to the IDE connector on
the main board. You must connect the IDE cable
as shown below.
11. Assemble the front panel and top case.
12. Fix the screws.
13. After installing the HDD, you must format the
HDD using the setup menu (See page 35).
Notes:
• When you add the new HDD, do not change the
position or jump setting of the HDD.
It may delete the current data and cause a mal-
function.
• You must connect the primary IDE cable to the
primary IDE connector on the main board and the
secondary IDE cable to the secondary IDE connec-
tor on the main board.
Replacing the Hard Disk Drive
Turn the power of the unit off and detach the power
plug from the outlet.
1. Follow steps 1-3 described in “Installing the Hard
Disk Drive”.
2. Remove the screws and detach the hard disk
mounting brackets from the unit.
3. Remove the connector from the HDD.
4. Remove the screws from the hard disk drive on the
left/right side of the hard disk the mounting bracket.
Extension
HDD power cable.
IDE1 (Primary
HDD connector)
IDE2 (Secondary
HDD connector)
Power cable for
power supply.
Primary IDE cable
Secondary IDE cable