Filter
Top Products
- 12
Recording TV-Audio Channels
This recorder can also record NICAM audio. If the
NICAM setting (page 20) is set to “Auto“, NICAM
audio will be recorded in the case of a NICAM
transmission.
Restrictions on Video Recording
You cannot record any copy-protected fi lm
material with this recorder. Copy-protected video
includes DVD-Video discs and some satellite
transmissions. If copy-protected material is en-
countered during recording, recording is paused
or stopped automatically and an error message
appears on the screen.
Video that can only be copied once can only be
recorded using a DVD-RW disc in VR mode with
CPRM (see below).
NTSC format signals from analog or DV inputs
cannot be recorded correctly with this recorder.
SECAM format video signals (from an integrated
TV tuner or from analog inputs) are recorded in
PAL format.
CPRM
CPRM is a copy protection system (with scramble
system) that only allows the recording of “copy
once“ broadcasts. CPRM is the abbreviation for
“Content Protection for Recordable Media”.
This recorder is CPRM compatible. You can
therefore record copy-once broadcasts but cannot
make copies of these recordings. CPRM recordings
are only possible with VR mode formatted DVD-RW
discs and can only be played on players with CPRM
compatibility.
•
•
•
•
Copyright
The recording equipment should only be used for
lawful copying. You should fi nd out what con-
stitutes lawful copying in the country in which
you are making a copy. Copying of copyrighted
material e.g. fi lms or music is only lawful if
permitted by a legal exception or consented to
by the rights owner.
The product contains copyright protection
technology that offers protection through certain
US patents and other intellectual property rights
and is the property of the Macrovision Corpora-
tion and other companies. Use of this copyright
protection technology must be authorized by the
Macrovision Corporation. It is only intended for
private or other limited use unless otherwise au-
thorized by the Macrovision Corporation. Reverse
engineering and disassembly are prohibited.
•
•
Initial Remote Control
Setup
+
+
To insert or change the batteries, press on the
imprinted arrow. Sldie off and remove the battery
compartment cover. Insert alkaline-manganese LR
03 (AAA) type batteries and make sure the + and
– poles are aligned correctly.
Then, replace the cover.
Resetting the DVD Recorder
If any of the following problems occur...
The unit is plugged in but will not turn on or off.
The display panel does not work.
The DVD recorder is not functioning normally.
.., the DVD recorder can be reset in the following
way:
Hold the
button down for at least 5 seconds.
The unit will switch off. Press the
button
again to switch the unit back on.
or unplug the power cable, wait at least 20
seconds and plug the cable back in.
•
•
•
•
•
Initial Installation