Filter
Top Products
18
SDR24/96
SDR 24/96
3. Select 1-8. The LCD display
shows you the current setting for
outputs 1-8, either Direct or
Custom.
4. Select Direct for direct track-to-output playback (i.e., Track 1 to Output 1,
Track 2 to Output 2, etc.).
5. Select Custom to route tracks to different output numbers.
6. Press the Inc (increment) and
Dec (decrement) buttons to
change the output number that is
assigned to Track 1. Select Apply
to save the change.
7. Press the Page Right
button to scroll to the next track. Repeat step 6
for Track 2, and so on.
8. Select Exit when finished with Tracks 1-8 to return to the previous menu.
Press the Page Left
button to return to the TRACK OUTPUT SELECT
menu to edit tracks 9-16 and 17-24.
9. Press the SETUP button when done.
Notes:
♦
You cannot route a track to more than one output.
♦
You cannot assign more than one track to a single output. Attempting to do
so will cause the output assignments to switch places for the two tracks.
Input Type Setup
The SDR24/96 can read only one input for each track, either analog or digital. This
must be configured in the Setup menu. Since these settings depend on how the SDR
is connected to the console, these are global settings, and are project independent.
To configure the input type format:
1. Press SETUP to enter the
SETUP MENU.
2. Select I/O.
3. Press the Page Right
button
two times to enter the INPUT
TYPE SELECT menu.
4. Select 1-8. The LCD display
shows you the current input
settings for the 8 inputs selected.
Select Analog when using the
DB25 Analog inputs, and ADAT when using the Digital optical inputs.
5. The SDR24/96 also provides the
option of customizing each input
individually for either analog or
digital formats. Select the Custom
button and use the Page Left
and Page Right buttons to scroll
through the 8 inputs. Choose either analog or digital for each input.
6. Repeat steps 4 and 5 for inputs 9-16 and 17-24.
TRK 1- 8 OUT: Direct
Direct Custom Exit
TRK 1 OUT: 1 ( 1) >
Inc Dec Apply Exit
Track
New
Setting
Current
Setting
SETUP MENU >
Record I/O Sync Transp
< INPUT TYPE SELECT
INP: 1-8 9-16 17-24
INP 1- 8 TYPE: ADAT
Analog ADAT Custom Exit
INP 1 TYPE: ADAT >
Analog ADAT Exit
Note: The front
panel display’s back-
light switches off
after ten minutes of
inactivity. You can
revive it at any time
by pressing either
the Page Left [<] or
Page Right [>] but-
ton, or any Select
button below the
display.