Magnavox 32MD251D Flat Panel Television User Manual


 
14
Installation
Select Autoprogram in the Installation menu.
Use the cursor right to enter the Autoprogram menu.
Press the OK button.
Select Cable or Antenna in the Installation mode.
When Antenna is selected, the TV will detect antenna
signals and will search for antenna TV (NTSC and ATSC) channels
available in your local area.
When Cable is selected, the TV will detect cable company
supplied signal sand will search for cable TV (NTSC, ATSC, QAM
modulated) channels available in your area.
Make sure that registration with your cable TV provider and
connection of equipment are completed.
Press the green button “Next” on the remote control.
Note: All channels must be unlocked in order to autoprogram. If
requested, enter your PIN code to unlock all channels. See Menu
preferences in the Settings, TV menu, p. 18.
Press the green button “Start” to start autoprogramming. The
menu screen disappears and the progress of autoprogramming is
displayed. The progress bar indicates the number of analog and
digital TV channels found.
When Autoprogramming is complete, a message appears
confirming the completion and the TV switches to the first
installed TV channel.
Settings
Setup
Exit
Info
Installation
Language
Autoprogram
Weak channel installation
Software upgrade
TV
Installation
Settings
Installation
Info
Autoprogram
Start now
Language
Autoprogram
Weak channel installation
Software upgrade
Television Installation
Installation mode
Previous Next
Antenna
Please select your
installation mode
Cable
Notes:
• When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code in
order to complete Autoprogramming.
• ATSC channel information is updated automatically when the TV is in standby after 3 minutes and every 3 hours thereafter.
• When channel update is interrupted, the new updated channel information is retained along with the old un-updated
channel information.
• Background Autoprogramming occurs only when the TV is turned on.
• Channel information about an ATSC channel is updated only for the ATSC channel currently tuned.
• If an NTSC channel is tuned, then in Background Autoprogramming the TV shall scan all the possible ATSC frequencies
and update information.
• Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thus
optimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 15.)
• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
• If Antenna/cable signal is interrupted more than ten minutes, TV will go into off mode. You are requested to press Power button
or CH / button to turn on the TV.
Select the menu language
Press the MENU button on the remote control.
Use the cursor down to select Installation in the Settings menu.
Use the cursor right to enter the Installation menu.
Select Language and enter the list of available languages with the
cursor right.
Select your preferred language with the cursor up/down and press
the OK button to confirm you selection.
Proceed with the Installation menu.
Store TV channels
1
2
3
4
5
6
1
2
3
4
5
6