Filter
Top Products
7
1
ANT 75‰
Y
our Cable TV signal into your home may be a
single, 75Ω (ohm) cable. If so, this connection
is very simple. Follow the step below to connect
your Cable TV signal to your new television.
1
Connect the Cable TV signal to the
75Ω jack on the TV. Screw it down fin-
ger tight.
BASIC CABLE TV CONNECTION
Cable TV signal from
Cable Company
(75Ω coaxial cable)
A
combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69).Your connection is easy
because there is only one 75Ω (ohm)
antenna jack on the back of your TV, and
that’s where the antenna goes.
1
If your antenna has a round cable
(75 ohm) on the end, then you're
ready to connect it to the TV.
If your antenna has flat, twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the
screws on a 300- to 75-ohm adapter.
2
Connect the antenna (or adapter)
to the 75Ω (ohm) jack on the back of
the TV. If the end of the antenna wire
is threaded, screw it down finger tight.
BASIC ANTENNA CONNECTION
Use Auto Program as described on page 12
to set up channels that are available in your
area. Use the CH +/– buttons to scan avail-
able channels.
HELPFUL HINT
1
ANT 75‰
2
Antenna
with 75Ω
cable
OR
Twin-lead
wire to
300-75Ω
adapter
Outdoor or Indoor Antenna
(Combination VHF/UHF)
75Ω jack on rear
of Television
75Ω jack on rear
of Television