Filter
Top Products
1
Make the connections shown above.
32 Rerecording (Tape Duplication)
3
VCR 2 will record your tape. Insert a blank tape in VCR 2.
The VCR must be in VCR position. (The VCR/TV light will
appear on the display panel. If it does not, press the VCR/TV
button once.)
4
Turn on the TV and set it to channel 03 or 04,
whichever channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press the
Number buttons 0, 0, 1 or 0, 0, 2. (See Helpful Hints at
right.)
6
Press the SPEED button to select SP or SLP at VCR
2.
7
Press the PLAY button on VCR 1 and the RECORD
button on VCR 2 at the same time.
To stop recording, press the Stop/Eject C/A button on VCR 1,
then press the Stop/Eject C/A button on VCR 2.
VCR 1
Playing VCR
VCR 2 - Recording VCR
2
VCR 1 will play your tape. Put a prerecorded tape in
VCR 1.
1. Audio cables from AUDIO OUT Jacks
of VCR 1 to AUDIO IN Jacks of VCR 2
2. Video cable from VIDEO OUT Jack
of VCR 1 to VIDEO IN Jack of VCR 2
3. RF coaxial cable
from the OUT jack of
VCR 2 to the TV’s
ANTENNA IN Jack
• If you use the AUDIO and VIDEO
IN Jacks on the back of VCR 2,
press Number buttons 0, 0, 1 at
step 5. AV REAR will appear on
the TV screen.
• If you use the AUDIO and VIDEO
In Jacks on the front of VCR 2,
press Number buttons 0, 0, 2 at
step 5. AV FRONT will appear on
the TV screen.
• Unauthorized recording of copy-
righted television programs, video
tapes, or other materials may
infringe on the rights of copyright
owners and violate copyright laws.
• If a program has copyright protec-
tion, it may not record clearly.
• These instructions show you how to
copy tapes using two MVR630MG
VCRs. Different VCRs may operate
differently.
• If you have the MVR430MG, you
only need one audio cable to con-
nect the single AUDIO OUT jack on
VCR1 to the AUDIO IN jack on
VCR2.
Helpful Hints
● Audio and Video cables are not supplied.
mvr630mg.QX33 2/11/02 12:05 PM Page 32