Filter
Top Products
11
SWITCHING ON
Take off the battery compartment cover from the back of the
Plaza HD•S2 remote control by lifting it up while pushing the catch.
Insert the two AAA batteries supplied, as shown on the inside of
the compartment, and replace the compartment cover.
HINT: The “F-connector” used for the satellite dish cable
connection has a central wire that is inserted into the hole
in the LNB IN socket while the collar is screwed onto the
socket. When screwing on the collar, make sure that the
central wire goes into the socket hole and is not bent to
one side.
Turn off your television and connect the HDMI cable supplied
between the HDMI socket at the back of your Plaza HD•S2 receiver
and an HDMI socket on your television. There may be more than
one HDMI socket on your television. If you are not sure which to
use, check the television’s manual.
Plug the power cable from the rear of the Plaza HD•S2 into an
available mains socket that is turned off.
You can also connect the Plaza HD•S2 receiver to a stereo or
surround sound system, so that you can listen to the TV sound
through the sound system instead of (or as well as) the television’s
speakers. If you connect an optical lead (not supplied) between the
S/PDIF sockets on your receiver and digital sound system, you can
listen to the TV sound in digital audio quality, or even in surround
sound, depending on the broadcast and your sound system.
HINT: If your television has no HDMI socket, then it must
be connected to the receiver by SCART cable, and you will
not be able to watch Freesat channels in high definition.
To watch On Demand TV services including BBC iPlayer and ITV Player,
the Plaza HD•S2 must be connected to your internet router or hub
using an ethernet cable (not supplied). Plug one end of the ethernet
cable into the ETHERNET socket at the back of the Plaza HD•S2, and
the other into your hub or router. Make sure the connections are fully
pushed in - you’ll hear a click as they lock into place. Consult your
router or hub’s documentation for further guidance.
If your receiver is not located near your hub or router, you could use
HomePlug powerline adapters to extend your home network using
the ring main of your house. Another option is to use a Wireless
Ethernet Bridge to bridge the Ethernet socket of the Plaza HD•S2
to Wi-Fi, enabling it to connect wirelessly to your home network.
For more information, please consult with your installer or retailer. If
you require support for these devices, you will need to contact the
manufacturer. The Plaza HD•S2 does not support USB Wi-Fi dongles.
B4