Manhattan Computer Products PLAZA HD-52 Satellite TV System User Manual


 
36
TUNING IN NON-FREESAT CHANNELS (continued)
The Plaza HD•S2 will take a few seconds to complete a Manual
Scan and about five minutes to finish an Auto Scan. While it
is scanning, the receiver displays the number of TV and radio
channels found so far. When it is finished, the receiver will display
a list of all the channels found.
You can choose to watch a non-Freesat channel from this list by
moving the orange bar using the and buttons to highlight
the channel you want and pressing
, or return to watching TV
by pressing or .
WATCHING NON-FREESAT CHANNELS
Non-Freesat channels and Freesat channels are stored separately
in the receiver but you can switch between them quite easily.
When you are watching a non-Freesat channel, the information
bar displays the Manhattan logo instead of the Freesat logo.
While watching a non-Freesat channel, you can step through the
other non-Freesat channels by pressing the
or buttons.
You can also switch directly to the channel you want using the
number buttons. All the non-Freesat channel numbers have four
digits. If you enter only the three digits of a Freesat channel, the
receiver will switch to that Freesat channel.
While watching a Freesat channel you cannot enter a four-digit
channel number to switch to a non-Freesat channel, but you can
press the
button to switch to the channel you last watched,
HINT: Non-Freesat TV channels are stored from channel
number 3001 and non-Freesat radio channels from 4001.