Filter
Top Products
39
ELECTRICAL SAFETY
Your receiver requires a 100V to 240V AC ~ 50/60Hz mains supply
and is fitted with a moulded plug. If the plug breaks or becomes
damaged do not use it. If you change the fuse in the plug ensure
you refit the fuse cover. If the plug requires replacement please
follow these instructions. The wires in the mains lead are coloured
in accordance with the following code:
As the colours in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured blue or black must be connected to
the terminal which is marked with the letter N or coloured Black.
BLUE - Neutral
BROWN - Live
FUSE
BROWN
(LIVE)
CABLE
GRIP
OUTER
SLEEVE
BLUE
(NEUTRAL)
NO CONNECTION
(EARTH)
The wire which is coloured brown or red must be connected to the
terminal which is marked with the letter L or coloured Red. No
connection is to be made to the Earth terminal of the plug as this
product is double insulated.
If a 13 Amp (BS1363) Plug is used, fit an ASTA approved (BS1362)
3 Amp fuse only. Your product is fitted with a moulded plug. If it
requires replacement please cut off and dispose of safely, then
rewire as shown opposite.
PROTECTING THE ENVIRONMENT
If you one day find that your receiver or remote control needs
replacing, or are of no further use to you, do not throw them
out with your household waste. Under the Waste Electrical and
Electronic Equipment (WEEE) regulations, your local council must
provide a suitable recycling centre.
Do not throw batteries in the bin or on a fire. Make sure that you
dispose of batteries safely at a local recycling centre. You can also
recycle batteries at many supermarkets.