Filter
Top Products
26
HOW TO USE THE REMOTE TO CONTROL YOUR TV
ቫ SLEEP button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15
minutes to this timer, up to a maximum of three hours. Once set, use RECALL when you want to view time remaining. If the SLEEP
button is pressed while the timer is set, it will reset to the original condition.
ቭ LAST CHANNEL (LAST CH) button
Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)
ቪ CHANNEL selector buttons
CHANNEL selector buttons are used to set FAMILY FAVORITES, CHANNEL MEMORY, etc.
Enter one, two, or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the “1” button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (̆) or down (̄).
You can also use these number buttons to directly access OSD sub-menus of your choice. While navigating the On-Screen-
Displays, you will notice that each sub-menu has a number next to it. For example, the SET UP menu has 9 sub-menus. Pressing
the ቨ button while in the SET UP menu will take you directly to the CLOCK SET sub-menu. This makes navigating the menus
faster and easier.
NOTE: The TV may not receive some channels if you are not in the correct SIGNAL SOURCE mode. (see page 41)
ANT A 10
ANT A 39
LAST CH
ቯ TV/PC button
Press this button to switch between TV, PC1 and PC2 modes.
ተ HELP button
Press this button when a menu is displayed to view HELP text, which gives a description of the displayed menu. The HELP text
will be displayed every time a MENU is displayed, until this button is pressed again.
ቱ ASPECT button
Press this button to quickly change the aspect ratio of the viewable picture in normal, full, fill, and smooth wide. (See page 46 and
47 for more information)
ቲ COMMERCIAL SKIP (C.S.) button
Press this button repeatedly to select channel skip time (30~180 seconds) when no menu is displayed and the TV will tune to the
last channel viewed when the selected amount of time is up. The user can change stations, “SURF” to any station they wish, and
after the selected amount of time, the TV will tune back to the original channel.
ታ MENU button
The MENU button will start the On-Screen Display.
ቩ CD, TAPE, AMP buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio/Video mode. (see page 35)
ቮ ANTENNA button
The ANT button will select between Antenna A and Antenna B each time the button is pressed.
Ant B 28
Ant A 10
ANT