Filter
Top Products
8
FRONT PANEL CONTROLS
ቦ POWER Light
This light is on during normal operation.
Light Blinking Slowly (2 seconds): Rear Projection Television lamp is cooling down. It takes 12-15 seconds to warm up and
about 2 minutes to cool down.
ቧ POWER Button
Press this button to turn the TV on or off.
ቨ FRONT INPUT JACKS (for VIDEO: 3 and PC2 AUDIO)
Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording.
Press the INPUT button until VIDEO: 3 appears in the top right corner of the TV screen. If you have mono sound, insert the audio
cable into the left audio jack. VIDEO: 3 audio input jacks can be used for PC2 audio when a PC is connected to front input VIDEO:
3 jack. When using S-Video cable on the front panel, make sure the arrow (Ȇ) marking on the S-Video cable points to the left, to
properly insert the S-Video cable into your television.
ቩ PC 2 (Front)
Use this 15 pin D-Sub input for a “quick” hook up from your PC connection.
ቪ TV/PC Button
Press this button to switch from TV, PC 1 and PC 2. Your selection is shown in the top right corner of the screen.
ቫ INPUT/EXIT Button
Press this button to select the current antenna source, VIDEO: 1, 2, 3 or alternate antenna source. Your selection is shown in the
top right corner of the screen. This button also serves as the EXIT button when in MENU mode.
ቭ MENU Button
This button allows you to enter the MENU, making it possible to set TV features to your preference without using the remote.
This button also serves as the SELECT button when in menu mode.
ቮ VOLUME Level
Press these buttons for your desired sound level. The volume level will be displayed on the TV screen. These buttons also serve
as the cursor left (ǡ) and right (Ǡ) buttons when in MENU mode.
ቯ CHANNEL Selector
Press these buttons until the desired channel appears in the top right corner of the TV screen. These buttons also serve as the
cursor down (Ĭ) and up (į) buttons when in MENU mode.
NOTE: COMPONENT INPUT takes priority over S-VIDEO input, and S-VIDEO input takes priority over VIDEO input.
NO LAMP LIGHT
or BROKEN LAMP
WRONG LAMP UNIT
ASSEMBLY
Too Hot inside the
OPTIC unit
COOLING FAN STOPPED
NORMAL
OPERATION
COOL DOWN
LIGHT ON
BLINKING
LIGHT ON
BLINKING
LIGHT ON
SLOWLY BLINKING
INDICATOR INDICATION MEANING ACTION
LAMP LED
TEMP
LED
POWER
Need to exchange if
LAMP still does not light by
Power On again.
Check assembly condition of
LAMP UNIT
Call Service
NOTES:
1.
2. If the LAMP, TEMP, and POWER LED are blinking in the order below, the Rear Projection Television is warming up.
LAMP TEMP POWER