Marantz DV4300 DVD Player User Manual


 
ENGLISH
32
CUSTOMIZING DVD PERFORMANCE
Once the initial settings have been completed, the player can always be operated under the same conditions whenever the power is
switched on. These settings are called SETUP data that are easily modified and stored using the SETUP menu. The SETUP menu
includes the information for AUDIO, VIDEO, OTHER system controls, LANGuages and parental LOCK. AUDIO and VIDEO
submenus deal with items related to AUDIO and VIDEO. The OTHER submenu deals with items related to other system controls.
LOCK submenu deals with items related to parental locks, they are parental levels and passwords. The submenu of SETUP is
differentiated by two categories. One is submenu changeable during play mode. The other is not. The ability to change during play
is on the AUDIO and VIDEO submenu. The other is OTHER, LANGuage and parental LOCK.
Audio
There are six sub items in the AUDIO submenu. They are DIGITAL OUT, LCPM OUTPUT, DOWNMIX, DUAL MONO,
OPERATIONAL and DYNAMIC RANGE. When you press the SETUP button and select AUDIO among the six submenus, the sub
items for AUDIO are displayed as shown in the figure below.
1. DIGITAL OUT
DIGITAL OUT item controls the output condition of digital out (coaxial or optical) connector. There are 3 values possible for
DIGITAL OUT. They are OFF, BITSTREAM and PCM. In case of OFF value, No digital signal can be output. Only analog audio
can be output. In case of BITSTREAM value, the original audio stream recorded on the disc is output through the digital out
connector. In case of PCM value, the decoded audio stream will be output through the digital out connector. The relation of
amplifier and DIGITAL OUT option is shown below.
DIGITAL OUT
LPCM OUTPUT
DOWNMIX
DUAL MONO
OPERATIONAL
DYNAMIC RNG
EXIT SETUP
BITSTREAM
LPCM 48K
LO/RO
STEREO
LINEMODE
0
Note
When a recorded in a Dolby Digital or DTS is loaded, noise will be output if you have made connections via the digital audio jacks
to a receiver or amplifier that cannot decode a Dolby Digital or DTS digital bitstream.
In this case, be sure to set up the SETUP, Audio setting; Digital out to PCM or OFF as above mentioned.
2. LPCM OUTPUT
If your AV amplifier is compatible with high sampling rate (96kHz), set this to LPCM 96k.
DTS Disc
PCM
DTS
Dolby Digital Disc
PCM
PCM
LPCM Disc
PCM
PCM
Bitstream
PCM
Bitstream
DTS
OFF
-
Bitstream
PCM
(Except
MP 3)
PCM
PCM
(Except
MP 3)
OFF
-
Bitstream
Dolby
Digital
OFF
-
OFF
-
Digital OUT Setting
Digital Audio output
DISC DVD VCD & CD & MP3
Note
• Even when set to
LPCM 96k, some discs will only output down sampled audio.
3. DOWNMIX (Dolby Digital DVD disc only)
DOWNMIX is used to reproduce the proper analog audio when the audio channel recorded on the disc differs from the output
audio channel configuration. Assume that 5.1 channels audio are recorded on the disc but you can receive only stereo audio
channels. In this case downmix is unavoidable and you will hear all the channels recorded on disc. There are two ways of
downmixing. One is LT/RT and the other is LO/RO. If you are using Dolby Surround Pro Logic decoder, please set the downmix
mode to LT/RT otherwise LO/RO.
LPCM out setting ANALOG OUT DIGITAL OUT
48k Disc 96k Disc 48k Disc 96k Disc
LPCM 48k 48k sampling 48k sampling 48k sampling 48k sampling
LPCM 96k 48k sampling 96k sampling 48k sampling 96k sampling