TroubleshootingInformationHDMI Control FunctionPlaybackSetupGetting Started Speciğcations
21
ENGLISH
Connecting to the Network
5. Updating to the UD9004’s Latest Software Version
You can update by downloading the latest ğrmware from the Internet. •
For more information, on the GUI menu, select “Other Setup” – “Firmware Update” (vpage 33).
See “Network Setup” (• vpage 31) on the GUI menu for more information on network setting.
Internet
Modem
Router
Computer
LAN port/
Ethernet
connector
To WAN port
To LAN port
To LAN port
NETWORK
connector
System Requirement
Internet Connection by Broadband Circuit n
Modem n
Device that connects to the broadband circuit and conducts communications on the Internet.
A type that is integrated with a router is also available.
Router n
When using the UD9004, we recommend a router with the following features.
Built-in DHCP (Dynamic Host Conğguration Protocol) server.•
Function that automatically assigns an IP address on the LAN.
Built-in 100BASE-TX switch (built-in switching hub compatible with speeds upwards of 100 Mbps)•
Ethernet cable (CAT-5 or greater recommended) n
An Ethernet cable is not included with the UD9004.•
For Ethernet cable, we recommend you use shielded straight cable (normal type). •
If you use the Ġat type or a non-shielded cable, the noise may adversely affect other devices.
For Internet connection, use an ISP (Internet Service Provider). Ask your local dealer for details.
NOTE
• It is necessary to subscribe to an ISP in order to connect to the Internet. If you already have a
broadband connection, there is no need to subscribe anew.
• The router you can use varies with the ISP. For more information, contact your ISP or PC dealer.
• MARANTZ assumes no responsibility whatsoever for any communication errors or troubles resulting
from customer's network environment or connected devices.
Others n
The UD9004 can use the DHCP function to automatically set the network.•
With the type of circuit in which network setting is performed manually, when subscribed to a provider, •
conduct the setting in accordance with “Network Setup” on the GUI menu (vpage 31).
If you connect the UD9004 to a network without a DHCP function, conduct IP address and other settings •
according to “Network Setup” on the GUI menu (vpage 31).
The UD9004 does not support PPPoE. If you subscribe to a circuit that is set with PPPoE, a PPPoE-•
compatible router is required.
When setting manually, check the setting contents with the network administrator.•
Connections
