Maxtor AVE MVDR-5000 DVR User Manual


 
17
ALM OPERATION
REC RATE
REC QUALITY
AUDIO
ALM TYPE
ALM DURATION
PRE-ALARM
MOTION SETTING
ALARM/ MOTION
MAIN PAGE
: OFF
: 30 F/S
: BEST
: OFF
: NO
: 0 SEC
: OFF
ALM OPERATION
REC RATE
REC QUALITY
AUDIO
ALM TYPE
ALM DURATION
PRE-ALARM
MOTION SETTING
ALARM/ MOTION
MAIN PAGE
: ON
: 30 F/S
: BEST
: OFF
: NO
: 0 SEC
: OFF
RECORD
ALARM / MOTION
TIMER/ SEQ/ TITLE
COMMUNICATION
DISK
SYSTEM
MAIN MENU
GOTO ALARM/ MOTION PAGE
RECORD
ALARM / MOTION
TIMER/ SEQ/ TITLE
COMMUNICATION
DISK
SYSTEM
MAIN MENU
GOTO ALARM/ MOTION PAGE
CH1
CH2
CH3
CH4
SENSITIVITY
MOTION SETTING
MAIN PAGE
: ON
: OFF
: OFF
: OFF
: 3
(8) Press the REC button
6
for 3 seconds
during the scheduled recording to stop it any
time. If you wish to continue the scheduled
recording, press the REC button
6
to
proceed.
Note: You can proceed to start the scheduled
recording from the current time if it is in the
scheduled interlude as soon as setting is
completed, and come out from the menu to
start recording.
Note: If you activate the recording function before
the scheduled recording, the unit will operate
recording as shown in the diagram below and
keep those Images in different files.
03:00 06:00 08:00 12:00 14:00
START END START END
Start Manual
Recording
Timer Manual Timer Manual
3.2.3 Alarm / Motion Recording
Take the following steps to activate the
programmed alarm recording. For the ALM
OPERATION, REC RATE, REC QUALITY,
AUDIO, ALM TYPE, ALM DURATION, and
PRE-ALARM settings, please refer to section
4.2 for more details.
(1) Press the Setup button
9
to enter the
MAIN MENU.
(2) Select ALARM / MOTION and press the
Enter button
15
to enter the ALARM /
MOTION.
(3) Set the desired REC RATE, REC
QUALITY, ALM TYPE, and ALM
DURATION settings for use. If audio is
required, set AUDIO to ON. If pre-alarm
recording is required, set PRE-ALARM to
ON.
(4) To activate/deactivate the alarm recording,
set ALM OPERATION to ON/ OFF.
(5) To active the motion alarm recording, select
MOTION SETTING and press the Enter
button
15
to enter the MOTION SETTING
page, set MOTION ENABLE TO ON, and
set a suitable SENSITIVITY and REGION
according to the video sources.