Filter
Top Products
15
System Settings
the setting mode by simply pressing the
MAIN button or bring the cursor to 8. TO
EXIT with the joystick and push the joy-
stick down.
Enter the Clock Setting Mode by moving
the cursor on the TOUCH SCREEN to 6.
SET DATE & CLOCK by using the joy-
stick. Enter this mode by pushing the joy-
stick down. Press the selection you wish to
change from the TOUCH SCREEN and
change them using the UP and DOWN
buttons. Once you complete the setting,
store them by pressing the SAVE button.
Move the cursor on the TOUCH SCREEN
to 1. TOUCH PAD ALIGNMENT with the
joystick. Press the joystick down to enter
the mode. Align the screen by pressing the
three points that appear on TOUCH
SCREEN one point at a time. Follow the
On-Screen instructions.
Note: If a new version of the Normal Modes
of Operation Firmware has been
uploaded into the UR12, a Touch
Screen Aligment Procedure must be
performed inorder for the Touch-
buttons to become active.
Move the cursor on the TOUCH SCREEN
to 2. SYSTEM & OPTIONS with the joy-
stick. Enter this mode by pushing the joy-
Clock Setting
Touch Screen Alignment
Systems and Options
stick down and the following can be set.
Refer to figure 9.
The TOUCH SCREEN (LCD) will list the
following choices:
Settings Range Default
Beep Status: High, Low, Off High
Light On Time: 0 120 20
(in seconds)
LCD On Time: 5 - 120 30
(in seconds)
Low Battery Warning: 10 - 50 10
(in percentage)
Select the button you wish to change from
the list first. Press the UP or DOWN but-
tons on the TOUCH SCREEN to set them
up. Once you set them up, press the SAVE
button to store them. You will be in the set-
ting mode once again. To return to the
main menu, move the cursor to 8. TO
EXIT and press the cursor down or simply
press the MAIN button to exit to main
menu.
C D
Figure 9