Filter
Top Products
12
CONNECTION TO OUTPUT DVD (CONTINUED)
CONNECTING THE UNIT TO A HOME THEATER SYSTEM
NOTES FOR CONNECTING TO A HOME THEATER SYSTEM:
•
If your
TV has a Component input, connect the unit with the component cable for best results, otherwise use the S-Video
or Video OUT jack on the unit.
• Set the TV’s TV/VIDEO button or switch to the VIDEO setting.
•
When connecting the unit, refer to the owner
’
s manuals for the TV and the audio system, as well as this manual.
• When connecting, make sure the power is off and all units are unplugged before making any connections.
• If using a TV with a blue screen option, turn the option off, on the TV for best results.
• If you place the unit near a tuner, the radio broadcast sound might be distorted. In this case, move the unit away from
the tuner.
• The Digital Audio Output can only be used for DVD playback, not for VCR or TV mode.
Place the subwoofer, front, rear and center
speakers in locations as shown/described
here. After correctly positioning the speakers,
perform the Tone Test on the AV Amplifier and
adjust the volume controls until the desired
sound is achieved. For best results, sit in the
viewing position and have someone adjust the
volumes for you; this will enable you to set the
optimal levels.
NOTE:
• The rear speakers can also be located on
the side wall facing the viewing position and
each other. Make sure the viewing position
is located between the two speakers in this
case. Experiment to find the optimal
position.