Filter
Top Products
13
CONNECTION (CONTINUED)
CONNECTING THE UNIT TO A TV USING THE COMPONENT CABLE (INCLUDED)
NOTES FOR CONNECTING TO A TV:
• TV must have Component (Y/PB/PR or Y/CB/CR) Input jacks.
• Set the TV’s TV/VIDEO button or switch to the VIDEO setting.
• When connecting the unit, refer to the owner’s manual of the TV, as well as this
manual.
• When connecting the unit to the TV, make sure the power is off and both units
are unplugged before making any connections.
• Connect the unit to your TV directly. If you connect the unit through a VCR, the
playback picture will be distorted because DVD video discs are copy protected.
• When using the Component Output, you should set the Component Output to
YUV in the VIDEO SETUP menu. Otherwise, the picture on the TV screen will
be incorrectly or not colored. See page 23 to set the Component Output to YUV.
• When the Component Output is set to YUV, the main unit's screen display will
turn off automatically. To observe the pictures on the unit's display screen again,
turn off the unit and then turn the unit on again, the Component Output will reset
to TV.