Filter
Top Products
Using the multimedia controller
9
Switching on and off
When not being used, the multimedia controller should be left in
the standby state. This uses a negligible amount of electricity,
but ensures that the components of the multimedia controller
operate at maximum efficiency from the moment you start.
If you are not going to use the multimedia controller for several
days you should switch the unit completely off at the back
panel, and disconnect it from the AC power supply.
To switch on from standby
● Press Source (front panel), or select a source by pressing the
appropriate source key on the remote: eg CD.
If the 562V Multimedia Controller is part of a Meridian system it
will automatically switch on any other unit in the system, such as
the CD player and Meridian DSP loudspeakers.
To switch to standby
● Press Off (front panel) or Standby (remote).
The display will show:
.
If you have other Meridian 500 Series equipment or Meridian
DSP loudspeakers connected to the multimedia controller, these
units will also switch to standby.