Filter
Top Products
1. Basic Setup and Operation 9
For assistance call 1(800) 332-2119
Press the
1.
TV
key to
ensure that the remote
control is in
TV
mode.
TV
TV
Aim the emitter (bulb)
2.
end of the remote control
at the TV and press the
POWER
key
.
Wait for the
Welcome screen.
If you wish to change the
3.
menu language to Español,
press .
Press
4.
to move to the
energy-mode selections.
Select Home.
Press
5.
to highlight EXIT.
Press
ENTER
to clear the
menu.
Welcome Screen Energy Options
Mitsubishi recommends the • Home setting,
which uses power within ENERGY STAR
®
guidelines.
The • Retail setting looks best under bright
lighting. In this mode, the TV uses power in
excess of ENERGY STAR guidelines.
This table compares energy choices offered in the
Welcome screen.
Home Retail
Picture Mode Bright Brilliant
Backlight Level
Reduced
Brightness
Full Brightness
First-Time Power-On
Setting Up and Using TV Inputs
Using the ANT (Antenna) Input
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV’s
ANT
input. Refer to page 16.
You must perform a channel scan to enable recep-
tion of digital channels. If you skip this step, the TV
will receive only analog channels. The channel scan
will search for high-definition and standard-definition
channels available in the local area.
Memorizing Channels with Channel Scan
For the ANT input
To start channel memorization
Power on the TV.
1.
Press
2.
MENU
and open the Setup > Channel menu.
First press to navigate to the Setup icon, then
use to highlight the Channel icon.
Start channel memorization from the Setup > Channel
menu.
Press
3.
to enter the menu.
Highlight
4.
Ant Air if connected to an
over-the-air antenna. Highlight Ant
Cable for service over direct cable
(no cable box). Press
ENTER
to add a
check.
For first-time setup, highlight
5.
All
channels. To scan for channels not
already in memory, highlight New
only. Press
ENTER
to add a check.
Highlight
6.
Scan and press
ENTER
.
Channel memorization may take up
to 15 minutes to complete.
To stop channel memorization before completion,
press
CANCEL
.