Filter
Top Products
38
Remote Control Functions: Operation
Figure 9. Installing the batteries.
Figure 8. Remote Control Functions.
Operation
Installing the Batteries:
(Figure 9)
1. Remove the remote control’s back cover by gently
pressing the ridged tab in the direction of the arrow
and sliding off the cover.
2. Load the batteries, making sure the polarities (+) and
(-) are correct. For ease of installation, install the
negative (-) side first.
For Best Results from the Remote Control:
Be within 20 feet of the equipment.
Do not press two or more buttons at the same time
unless instructed to.
Do not allow to get wet or become heated.
Avoid dropping on hard surfaces.
Do not use harsh chemicals to clean. Use only a
soft, lightly moistened cloth.
Do not mix new and old batteries.
Do not heat, take apart, or throw batteries into fire.
Use only AA batteries.
Operating the Remote Control:
You can use the remote to control the LCD Display
and other A/V (CABLE/DBS/DTV, VCR, DVD,
and AUDIO) products. Select the product you
want to control by moving the slide switch to the
appropriate position. The remote control has
been preset to operate the LCD Display and other
Mitsubishi products. To program the remote control
to operate other products, see Use of the Remote
Control with Other A/V Products, page 40.
The remote control may return to its initial setting
when the batteries are changed. You may need to
reprogram.
1
3
2
4
5
6
7
9
12
11
16
15
10
14
13
18
24
21
23
17
19
20
22
8