Filter
Top Products
73
73
Appendix B: Input Connection Compatiblity
Appendix B: Input Connection Compatibility
These inputs are compatible with component
video signals from standard DVD players
and other equipment sending a standard
NTSC component video signal (480i).
These inputs may also be compatible with
newer DVD players sending a progressive
NTSC component video signal (480p).
Component-1 and Component-2 Inputs
Input Levels and Timing with Com-
ponent Video
Y =1.0Vp-p (includes sync) 75-Ohms
Pr =700mVp-p, 75-Ohms (can also
receive signals from outputs labeled
R-Y and Cr)
Pb =700mVp-p, 75-Ohms (can also receive
signals from outputs labeled B-Y and Cb)
INP-DTV
This input is compatible with most standard
DTV and satellite receivers with component
video (YPbPr) outputs. Compatible DTV sig-
nals are SDTV 480i/480p, and HDTV 1080i.
All other DTV signals, such as 720p, need to
be converted by the DTV receiver to one of
the compatible signal types. Please check
the DTV receiver speci cat ions bef or e con-
necting.
This input is compatible with some DTV
receivers using RGB with sync on green
or with “separate H and V sync”. Com-
patible DTV signals are SDTV 480i, 480p,
and HDTV 1080i. All other DTV signals,
such as 720p, need to be converted by the
DTV receiver to one of the compatible signal
types. Industry standards for DTV RGB sig-
nals systems, synchronization, timing, and
signal strengths are not currently estab-
lished. These inputs will not be compatible
with all DTV receivers that offer RGB. If
your DTV receiver offers both DTV compo-
nent video signals and DTV RGB signals,
Mitsubishi suggests you use the DTV com-
ponent video signals. Please check the
DTV receiver speci cat ions bef or e connect -
ing.
Input Levels and Timing When
Used With Component Video
Signals
EIA - 770.3 Standard Levels and Timing
Y =1.0Vp-p (includes sync) 75-Ohms
Pr =700mVp-p, 75-Ohms
Pb =700mVp-p, 75-Ohms
H =Not Used
V =Not Used
Input Levels and Timing When Used
With RGB Video Signals
G (Y) =1.0Vp-p 75-Ohms
R(Pr) =700mVp-p, 75-Ohms
B(Pb) =700mVp-p, 75-Ohms
H =4Vp-p+/-1.0v, 75-Ohms
(when using separate H and V sync)
V =4Vp-p+/-1.0v, 75-Ohms
(when using separate H and V sync)
VGA Input
This input will accomodate most computers
capable of supporting a VGA monitor.
The only compatible display resolution is
640x480. The sync rate is 60 Hz. SVGA
and XVGA resolutions are not supported.