Mitsubishi Electronics PD-6130 Flat Panel Television User Manual


 
3
Rear View/ Terminal Board
A AC IN
Connect the included power cord here.
B EXT SPEAKER L and R
Connect speakers (optional) here. Maintain the correct
polarity. Connect the (positive) speaker wire to the
EXT SPEAKER terminal and the (negative)
speaker wire to the EXT SPEAKER terminal on both
LEFT and RIGHT channels.
Please refer to your speaker’s owner’s manual.
C VIDEO1, 2, 3 (BNC, RCA, S-Video)
Connect VCR’s, DVD’s or Video Cameras, etc. here.
VIDEO1 can be used for Input or Output (see page 10).
D AUDIO1, AUDIO2, AUDIO3
These are audio input terminals.
The input is selectable. Select the individual video setting
from the audio menu screen.
E DVD1 / HD1
Connect DVD’s, High Definition or Laser Discs, etc.
here.
F RGB2/ DVD2/ HD2
RGB2: You can connect an analog RGB signal
and the syncronization signal.
DVD2/ HD2: You can connect DVDs, High Definition
sources, Laser Discs, etc. here.
This input can be set for use with an RGB
or component source. (see page 22)
G RGB1 (mini D-Sub 15pin)
Connect an analog RGB signal from a computer, etc. here.
This input can be used for Input or Output. (see page 10)
H MONITORLINK™ / DVI (Digital RGB)
MonitorLink when used with MonitorLink Control is a
Mitsubishi exclusive proprietary digital interface for the
display of high quality digital video signals from a
Mitsubishi HD Receiver/Controller, such as the HD-5000.
The MonitorLink input can also be used as a DVI input
from other sources. The left and right audio allow the
external Mitsubishi HDTV Receiver/Controller or DVI
set-top box to provide audio to the TV to be able to use
the TV speakers. When MonitorLink is used as DVI, it is
HDCP compatible.
Note:
When MonitorLink is used as a DVI-HD input,
the terminal is compliant with EIA-861 standards for
extended and high definition video, however, this input
is not intended for use with personal computers or
devices outputting video signals with computer
resolution.
I MONITORLINK™ CONTROL / RS-232C
A digital control interface that works in conjunction with
MonitorLink. While MonitorLink provides the digital
video signal, MonitorLink Control provides enhanced
functioning such as automatic power ON/OFF and input
selection. If you are not connecting a Mitsubishi HDTV
Receiver/Controller with MonitorLink features,
MonitorLink Control can be used as an RS-232C control
signal input port with an external control system. Please
visit www.mitsubishi-tv.com for RS-232 command
protocol.
J REMOTE IN
Connect the remote cable to the remote control’s remote
jack to obtain wired remote control.
K REMOTE OUT
Connect the remote cable to the REMOTE IN jack of the
other display monitor to obtain wired remote control.
VIDEO
(
IN /OUT
)
VIDEO
1
VIDEO
2
VIDEO
3
AUDIO
1
DVD
1
/
HD
1
R
(
MONO
)
L
Y Cb/Pb Cr/ Pr
RGB
2
/
DVD
2
/
HD
2
RGB
1
R/
VD
G/ B/
HD
(
IN /OUT
)
DVI
(
Digital RGB
)
AUDIO
2
R
(
MONO
)
L
AUDIO
3
R
(
MONO
)
L
Cr/Pr Y Cb/Pb
MONITORLINK
AB
D
C
E
F
G
H
I
J
K
MONITORLINK
CONTROL
IN OUT
REMOTE