Mitsubishi Electronics PD-6130 Flat Panel Television User Manual


 
9
5 4 3 2 1
15 14 13 12 11
10 9 8 7 6
MonitorLink™ Connections
MonitorLink and MonitorLink Control
1. Connect a MonitorLink cable from the Mitsubishi
Receiver/Controller back panel to the plasma monitor
back panel.
2. Connect the L (left) and R (right) audio cables from
the Mitsubishi Receiver/Controller to AUDIO LEFT
and AUDIO RIGHT on the MonitorLink section of the
plasma monitor back panel.
3. Connect the MonitorLink Control cable from the
Mitsubishi Receiver/Controller back panel to the plasma
monitor back panel.
Note:
1. Input TMDS signals conforming to DVI standards.
The TMDS input corresponds to 1 link.
2. To maintain display quality, use a cable with a quality
prescribed by DVI standards that is within 5 meters in length.
External DVI Device with DVI-HDCP
1. Connect a DVI cable from the DVI output of the external
DVI type device to the MonitorLink/DVI-HD input on
the back of the plasma monitor.
2. Connect the L (left) and R (right) audio cables from
the external DVI device to AUDIO LEFT and AUDIO
RIGHT on the MonitorLink section of the plasma
monitor back panel.
Note:
When used as a DVI Input, MonitorLink input is
compliant with HDCP and the EIA-861 standards for
standard, extended and high definition video. This input
is not intended for use with personal computers or devices
outputting video signals with computer resolution.
MonitorLink™ Pin Configuration
(DVI Connector)
The unit is equipped with a type of connector commonly
used for digital signals.
(This cannot be used for an analog input.)
(TMDS can be used for one link only.)
Signal (Analog)
Red
Green or sync-on-green
Blue
No connection
Ground
Red ground
Green ground
Blue ground
No connection
Sync signal ground
No connection
Bi-directional DATA (SDA)
Horizontal sync or Composite sync
Vertical sync
Data clock
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
12345678
910111213141516
20191817 21 22 23 24
MonitorLink™ / DVI
Pin Assignments and Signal Levels
for 15 pin RGB (Analog) Connector
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
Signal (Digital)
T.M.D.S Data 2 -
T.M.D.S Data 2 +
T.M.D.S Data 2 Shield
No connection
No connection
DDC Clock
DDC Data
No connection
T.M.D.S Data 1 -
T.M.D.S Data 1 +
T.M.D.S Data 1 Shield
No connection
No connection
+5V Power
Ground
Hot Plug Detect
T.M.D.S Data 0 -
T.M.D.S Data 0 +
T.M.D.S Data 0 Shield
No connection
No connection
T.M.D.S Clock Shield
T.M.D.S Clock +
T.M.D.S Clock -