Filter
Top Products
24
24
TV
AUDIO
CABLE/DBS DVD
VCR
1
Code to enter:
To reset to default code, enter 000
Cable box brand
General Instruments
Jerrold
Oak
Pioneer
Scientific Atlanta
Zenith
111, 119, 120, 121, 122,
123, 124, 125, 126, 127
102, 137, 139
101, 116
111, 112, 113
100, 117
If your
cable box
code is not
listed here,
please see
page 62
for a
complete
listing.
Cable Box Codes
3
2
POWER
Figure 1. Programming the remote to control your cable
box.
Figure 3. Programming the remote to control your VCR.
TV
AUDIO
CABLE/DBS DVD
VCR
1
2
POWER
Code to enter:
To reset to default code, enter 000
VCR brand
Mitsubishi
Hitachi
JVC
Phillips / Magnivox
Panasonic
RCA
Sony
Toshiba
001, 002
020, 043, 065
030, 054, 059
043, 044, 051
041, 042, 043
020, 053, 065
048, 049, 050
021, 066
If your
VCR
code is not
listed here,
please see
page 62
for a
complete
listing.
VCR Codes
3
TV
AUDIO
CABLE/DBS DVD
VCR
1
2
POWER
Code to enter:
To reset to default code, enter 000
Satellite brand
Mitsubishi - DBS
Dishnetwork
Hughes - DSS
RCA - DSS
Sony - DSS
Toshiba - DSS
Panasonic - DSS
Primestar
173
175
173
176
177
170
174
178
If your
satellite
receiver
code is not
listed here,
please see
page 62
for a
complete
listing.
Satellite Receiver Codes
3
Figure 2. Programming the remote to control your satel-
lite receiver.
If you cannot turn the cable box ON
by pressing POWER, try pressing CHAN-
NEL or the number buttons.
When set to TV, the PLAY, STOP, REW/
REV, and FF/FWD buttons will operate
the VCR after the VCR codes have been
properly programmed into the remote
control.
Part III: Setup
Programming the Remote Control: To Control Other A/V Products
Programming the Remote Control: To Control Other A/V Products
To Program the Remote to Control
Other Brands of Audio and Video
Products:
(Figures 1-5)
1
Move the slide switch at the top of
the remote to the product you want to
control.
2
Press and hold the POWER button on
the remote control.
3
Enter the rst three digit code listed for
your equipment, and then release the
POWER button on the remote control.
4
Point the remote control at the equip-
ment and press the POWER button.
If the equipment responds, the remote
control is properly programmed to oper-
ate the equipment. If the equipment
does not respond, repeat steps 2-4 with
the next three digit code listed in step 3
for your equipment.