Filter
Top Products
26
26
Part III: Setup
Activation of the System 4 Home
Theater IR Control
You can, with certian digital A/V receivers,
set up the remote control to automatically
select the correct audio input when you
press the HOME THEATER button. At the
same time, the TV will select the correct
video input. This allows you to watch your
best type of video (Component, S-Video)
with your best type of audio (Dolby Digital,
Pro Logic, etc.) conveniently. See System
4 Home Theater IR Control, page 20, for
connection instructions.
Once properly activated, when the HOME
THEATER button is pressed, System 4 Oper-
ates in 2 parts:
AUDIO
Changes a compatible digital A/V
receiver to the correct input for the device
you wish to operate.
VIDEO
Changes the TV to the correct input
for the device you wish to operate.
Both functions can operate simultaneously
with one touch of the HOME THEATER
button. However, you may activate only one
if you desire (video to control the TV or
audio to control the A/V Receiver). The
remote control must be programmed to the
appropriate A/V Receiver code prior to the
activation of the audio portion (see To Pro-
gram the Remote to Control Other Brands of
Audio and Video Products, page 24).
Programming the Remote Control:
To Activate the System 4 Home Theater IR Control
Models VS-60719 and VS-70709
Activate the System 4 Home Theater IR Control
To Activate the Audio Portion:
1
Press and hold the HOME THEATER button.
2
Press and release the AUDIO button.
To Activate the Video Portion:
(Figure 1)
1
Press and hold the HOME THEATER button.
2
Press and release the VIDEO button.
3
Name the TV input as instructed.
Name Input
Cannot be named
CABLE
DBS
VCR
DVD
Device You Are Using
Cable Box connected to ANT-A or ANT-B
Cable Box connected to Inputs 1-3
Satellite Receiver connected to any input
VCR connected to Inputs 1-3
DVD connected to Inputs 1-3
Name TV Input as Shown Below
(see pg 36 for naming help)
3
2
VIDEO
1
HOME
THEATER
Figure 1. Activating the video portion of System 4.