Using the remote control to operate VCRs, cable
boxes and other components (cont.)
Important:
b Important:
notes about your remote control
Sometimes manufacturers will change their products, or they may
use more than one code. If this is the case, your remote may not be
able to operate your VCR or cable box.
When you replace the batteries in your remote control, the remote
will usually return to its initial setting. You may need to set up
your remote again.
using your remote control to operate your Mitsubishi laser-
disc player
After you have set up your remote control for your laserdisc player,
you can use the remote to operate it.
O Use the select switch on the remote control to choose the
layer that you set up to operate your laserdisc player,
AUDIO or DVD.
O Point the remote control at the laserdisc player and press
the desired buttons.
You can use the POWER, CHANNEl,, numbers (0-9), INFO,
MENU, CANCEL, STOP, PAUSE, REW, PLAY, cursor ( • • ),
and FF buttons to operate your disc player.
using your remote control to operate your Mitsubishi A/V
receiver
After you have set up your remote control for your A/V receiver, y_ou
can use the remote to operate it.
Use the select switch on the remote qontrol to choose the
layer that you set up to operate your recover: TV or
AUDIO.
Point the remote control at the A!V receiw_r and press the
desired buttons.
If you are using a Mitsubishi HTS-100 receiver, you can use the
POWER, VOLUME, and MUTE buttons to operate it.
If you are using a Mksubishi HTS-300 receiver, you can use the
POWER, CHANNEL, INPUT, VOLUME, ENTER, number (0-9),
INFO, MENU, CANCEL, AUDIO, VIDEO, ADJUST, and MUTE
buttons to operate it.
If you are using a Mitsubishi M-¥_R400, M-VR600, M-VR800 or
MVR1000, you can use the POWER, VOLUME, number (0-9), and
MUTE buttons to operate the receiver. The cursor buttons will
access the M-VRS00 and M-VR1000 menus.
If you are using a Mitsubishi M-CD500 CD changer, you can use
the PLAY, PAUSE, STOP, FF, and REW buttons to operate the
changer.
Getting Started
45