Filter
Top Products
4
5
Internal Fans
Internal cooling fans maintain proper operating tempera-
tures inside the TV. It is normal to hear the fans when
you first turn on the TV, during quiet scenes while viewing
the TV, and for a short time after shutting off the TV.
About thirty seconds after shutting off the TV you may
notice the fans getting louder. This is normal during rapid
cool-down of the lamp.
Cleaning Recommendations
Normally, light dusting with a dry, non-scratching duster
will keep your TV clean. If cleaning beyond this is needed,
please use the following guidelines:
First, turn off the TV and unplug the power cord from the
power outlet.
Occasionally clean dust build-up from the air-intake grilles
on the back and sides of the TV. Clean using a vacuum
cleaner with a brush attachment.
Top and Sides of the TV
Gently wipe down your TV with a soft, non-abrasive •
cloth such as cotton flannel or a clean cloth diaper,
lightly moistened with water. Dry with a second dry,
soft, non-abrasive cloth.
For oily dirt, add a few drops of mild liquid detergent, •
such as dishwashing detergent, to the water used to
moisten the cloth. Rinse with a second cloth moist-
ened only with water. Dry with a third dry, soft, non-
abrasive cloth.
Glossy Surfaces (835 series models)
Use the soft cleaning cloth supplied with the TV.
• Cleantheclothbeforeeachusebyshakingorbrush-
ing to remove any residual dirt particles.
•
Gently wipe down the glossy surfaces of your TV with
the soft cloth. Do not apply pressure while wiping.
• Ifnecessary,lightlydampenthesoftclothwithwater.
Do not use chemical or abrasive cleaners.
• Washthesoftclothbyhandormachine.Useonly
mild soap.
Screen
Follow the instructions for the top and sides, wiping •
gently in an up and down motion.
Clean the entire screen evenly, not just sections of the •
screen.
Do not allow liquid to drip down the screen, as some •
liquid may enter the TV through the gap between the
screen and screen frame.
You may purchase Mitsubishi Screen Cleaner, part •
number CLEANER-VSS, by calling (800) 553-7278.
General Cleaning Precautions
DO NOT allow liquid to enter the TV through the venti-•
lation slots or any crevice.
DO NOT use any strong or abrasive cleaners, as •
these can scratch the surfaces.
DO NOT use any cleaners containing ammonia, •
bleach, alcohol, benzene, or thinners, as these can
dull the surfaces.
DO NOT spray liquids or cleaners directly on the TV’s •
surfaces.
DO NOT scrub or rub the TV harshly. Wipe it gently.•
Lamp Replacement
For lamp-replacement instructions, see Appendix E.
To Order a Replacement Lamp Under Warranty
Call (800) 553-7278. Please have model number, serial
number, and TV purchase date available.
Important: All lamps replaced under warranty must
be returned to Mitsubishi where they will be inspected
for defect verification.
To Purchase a Replacement Lamp After Warranty
Visit our website at www.mitsuparts.com or call
(800) 553-7278. Order new lamp part number
915B403001.
Please read the following safeguards for your TV and
retain for future reference. Always follow all warnings
and instructions marked on the television.
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
Important Information About Your TV
Installation Notes
Stand Requirement
CAUTION: Use these Mitsubishi TV models only with the
Mitsubishi stand models shown here. Other stands can
result in instability and possibly cause injury.
TV Model Stand Model
WD-60735, WD-65735
WD-65736
MB-S60/65
WD-73C8
WD-73735
WD-73736
MB-S73
835 Series Stands
Mitsubishi does not design, manufacture or sell matching
bases for 835 series model televisions (WD-65835, WD-73835).
When selecting a stand, base or other furniture to support the
TV, please make sure it is designed with the appropriate dimen-
sions for stability and to support the TV’s total weight as well
as the weight of any additional equipment you plan to store.
Custom cabinet installation must allow for proper air
circulation around the television.
NOTE TO CATV SYSTEM INSTALLER: THIS REMINDER IS
PROVIDED TO CALL THE CATV SYSTEM INSTALLER’S ATTEN-
TION TO ARTICLE 820-40 OF THE NEC THAT PROVIDES GUIDE-
LINES FOR THE PROPER GROUNDING AND, IN PARTICULAR,
SPECIFIES THAT THE CABLE GROUND SHALL BE CONNECTED
TO THE GROUNDING SYSTEM OF THE BUILDING, AS CLOSE
TO THE POINT OF CABLE ENTRY AS PRACTICAL.
TV Software
Do not attempt to update the software of this TV with software
or USB drives not provided by or authorized by Mitsubishi Digital
Electronics America, Inc. Non-authorized software may damage
the TV and will not be covered by the warranty.
Important Safety Instructions
10) Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.
11) Only use attachments/accessories specified by the
manufacturer.
12) Use only with the cart,
stand, tripod, bracket,
or table specified
by the manufacturer,
or sold with the
apparatus. When
a cart is used, use
caution when moving
the cart/apparatus
combination to avoid
injury from tip-over.
13) Unplug this apparatus during lightning storms or
when unused for long periods of time.
14) Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
ANTE NNA
LE AD IN WIRE
ANTE NNA
DIS CHAR GE UNIT
(NEC AR TICLE 810-20)
GR OUNDING
CONDUCTOR S
(NEC AR TICLE 810-21)
GR OUND CLAMPS
POWE R S ER VICE GR OUNDING
ELE CTR ODE SYSTE M
(NEC AR T 250, PAR T H)
GR OUND CLAMP
ELE CTR IC
SE RVICE
EQUIPMENT
NEC — NATIONAL ELE CTR ICAL CODE
EXAMPLE OF ANTE NNA GR OUNDING
Outdoor Antenna Grounding
If an outside antenna or cable system is connected
to the TV, be sure the antenna or cable system is
grounded so as to provide some protection against
voltage surges and built-up static charges.
Replacement Parts
When replacement parts are required, be sure the
service technician has used replacement parts speci-
fied by the manufacturer or have the same character-
istics as the original part. Unauthorized substitutions
may result in fire, electric shock or other hazards.