Filter
Top Products
12 1. Basic Setup and Operation
For assistance call 1(800) 332-2119
Setting Up Inputs with Auto Input Sensing
Power on the TV.
1.
Power on the devices to ensure detection.
2.
Connect one device to the TV, making note of the
3.
TV input jack.
The TV will display the New Device Found screen if
the connection type is detectable.
Highlight the device type in the on-screen list and
4.
press
ENTER
. The name you select here will appear
in the Input Selection menu.
Sample New Device
Found screen.
Important Note for NetCommand Users
838 Series. Be sure to select the correct device
type here. Although you can change the device type
later using the Inputs > Name menu, any “learned”
NetCommand IR codes will be erased when you
make the change.
Press
5.
EXIT
to close the New Device Found screen.
Repeat the preceding steps for each for each addi-
6.
tional device you want to add.
Using the ANT (Antenna) Input
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV’s
ANT
input. Refer to page 24.
You must perform a channel scan to enable recep-
tion of digital channels. If you skip this step, the TV
will receive only analog channels. The channel scan
will search for high-definition and standard-definition
channels available in your area.
Memorizing Channels with Channel Scan
For the ANT input
To start channel memorization
Power on the TV.
1.
Press
2.
MENU
and open the Setup > Channel menu.
Start channel memorization from the Setup > Channel
menu.
Press
3.
to enter the Channel menu.
Highlight
4.
Ant Air if connected to an
over-the-air antenna. Highlight Ant
Cable for service over direct cable
(no cable box). Press
ENTER
to add a
check.
Select the scan type.
5.
For first-time setup, highlight • All
channels.
To scan for channels not already •
in memory, highlight New only.
Press
ENTER
to add a check.
Highlight
6.
Scan and press
ENTER
.
Channel memorization may take up
to 15 minutes to complete.
To stop channel memorization before completion,
press
CANCEL
.
At any time after Channel Scan,
Use the • Setup > Channel > Edit menu (page 55) to
add or delete individual channels from memory.
Perform an additive scan with the • New only option
to add channels not already in memory.
Repeat the • All channels scan if you move the TV
to a new geographic area with a different channel
line-up or reposition the antenna.
Setting Up TV Inputs
Downloaded From TV-Manual.com Manuals