Filter
Top Products
72 6. NetCommand Control of an A/V Receiver (838 Series)
For assistance call 1(800) 332-2119
Setting Up A/V Receiver Control, continued
NetCommand Control of a Device Con-
nected to an HDMI A/V Receiver
Use this setup to have NetCommand control a device
sending audio and video through the A/V receiver to the
TV via HDMI.
You must have already completed the procedure under
“Setup to Control Automatic Audio and Video Switch-
ing via HDMI” on the previous page. That procedure
placed an icon in the Input Selection menu for the
device (input) connected to the A/V receiver.
HDMI
Cable
TV
Any Connection
Type
Source
Device
A/V
Receiver
Set up NetCommand control of A/V receiver audio/
1.
video switching via HDMI as described on the pre-
vious page.
Press
2.
EXIT
to close any open menus and return to
normal TV viewing.
Press
3.
INPUT
.
Highlight the icon for the device connected to the
4.
A/V receiver input you wish to control.
Press
5.
ENTER
to switch the TV to the A/V receiver
and the A/V receiver to the input.
Open the
6.
Inputs > Learn menu.
Perform NetCommand “learning” for the con-
7.
nected device by following the steps in “Initial
NetCommand Setup,” page 64.
Downloaded From TV-Manual.com Manuals