Filter
Top Products
Media Center User Guide © 2006 by Digeo, Inc. All rights reserved.
Using and programming the remote
44
Programming the remote
Before you begin, find the codes for your TV from the table starting on
page
78. Write it here:
____________________________________________________________
____________________________________________________________
____________________________________________________________
If you have an audio receiver, find the codes in the table starting on
page
85. Write it here:
____________________________________________________________
____________________________________________________________
____________________________________________________________
Use one of the following procedures:
• Programming with codes
• Programming by search on page 45 — use this if your brand is
not listed or if the given codes do not work.
Programming with codes
Follow these steps to program the remote to control TV power and
volume.
1. Turn on the TV or audio device you want to control.
2. On the Moxi remote, press and hold the Moxi and OK buttons simul-
taneously until the LED at the top of the remote blinks twice.
3. Using the number buttons on the remote, enter one of the codes for
the TV. When you enter the correct code, the LED blinks twice. If it
blinks once, the code was invalid—try another code.
4. Press the Power button on the remote.
5. If the TV does not respond, repeat steps 2 and 3 using another listed
code. Repeat until successful, or use Programming by search on
page 45.
6. To program the remote to control TV power plus power and volume
for an audio device, turn on the audio device you want to control.
7. Repeat Step 3 using the code for the audio device.
8. Press the Power button on the remote. If you programmed two
devices, both turn off.
9. If the TV or audio device does not respond, repeat steps 2 and 3
using another listed code. Repeat until successful, or use the Pro-
gramming by Search procedure.
Some older devices may not be supported. If the device fails to
respond to any code, use its original remote to control it.