Filter
Top Products
GB 16
Start/stop watching TV
To start the Mediamaster from stand-by mode, press the but-
ton, TV button or one of the number buttons on the remote con-
trol.
It is also possible to start by pressing the button behind the
lid on the front of the Mediamaster.
Put the Mediamaster into stand-by by pressing the button.
In stand-by mode the display will show the correct time.
Select Channel
Change channel with the numbered buttons or with the
up/down buttons on the remote control. You can also use the
buttons on the front panel of the Mediamaster.
Programme Information. The “ “ Button
Every time you change channel you will receive information for
4-5 seconds about the current programme. This information in-
cludes: Channel number, name, title and time.
Press “i” while watching a channel. If your Service Provider trans-
mits programme information you will see:
Correct time;
A small amount of information for the current and next pro-
gramme. (Alternate between “Now” and “Next” with the left/
right buttons);
Name and number of the channel;
Finally the start and stop time for the programme.
Important general information
The following will describe the basic functions of your Media-
master during the watching of TV or listening to Radio channels
from the Mediamaster. Sometimes the information may not be
displayed as illustrated. Many of the functions described here are
dependent on the Service Provider and/or can only be used if they
are included in the transmitted programme information.
Please note, that during the Channel Search procedure, the
Mediamaster has downloaded ALL available channels. This may
include channels from various Service Providers, also those to
which you normally do not have access, (unless you have a Smart
Card from one of those Service Providers).
If you select a programme to which you do not have access, you
will get the message “No Smart card” on the screen.
Viewing TV