Nokia 9200S Satellite TV System User Manual


 
GB 2
Important Information
Wiring the plug (UK and Eire only)
The mains lead on this product is already fitted with a non-rewireable (moulded)
plug incorporating a fuse, the value of which is indicated on the pin face of the
plug. Should the fuse need to be replaced, an ASTA or BSI approved BS 1362
fuse must be used of the same rating, marked thus:
If the fuse cover is detachable always refit the cover after replacing the fuse.
NEVER use the plug with the fuse cover omitted.
If the fitted plug is not suitable for your socket outlets it should be cut off, after
having first removed the fuse, and an appropriate plug fitted in its place. If this
new plug contains a fuse its value should be the same as that removed from the
non-rewireable plug.
The severed plug must be destroyed immediately to avoid the possible shock
hazard should be inserted into a 13A socket elsewhere.
If you need to replace the mains plug then follow the instruction given below:
The wires in the mains lead are coloured in accordance with the following code:
BLUE - Neutral (N); BROWN - Live (L).
As these colours may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire coloured BLUE must be connected to the terminal marked with the
letter N or coloured BLUE or BLACK.
The wire coloured BROWN must be connected to the terminal marked with the
letter L or coloured BROWN or RED.
On no account either of these wires to the terminal marked E or coloured GREEN
or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is clamped over
the sheath of the lead; not simply over the two wires.
If in doubt, consult a competent electrician.