Filter
Top Products
9.5 Remote Commands and Error Codes
The following tables list all commands, and their descriptions, that
are accepted by the calibrator.
Table 5: Common Commands
Command Description
*CLS (Clear status.) Clears the error queue.
*IDN? Identification query. Returns the manufacturer, model
number, and firmware revision level of the Calibrator.
*RST Resets the calibrator to the power up state.
Table 6: Calibrator Commands
Command Description
DAMP Turns Damp on or off.
DAMP? Returns if DAMP is on/off
DISPLAY Turns on/off the displays specified in the command
DISPLAY? Returns which displays are on/off
FAULT? Returns the most recent error code
ERROR_LOOP Turns loop power on or off in percent error mode
ERROR_LOOP? Returns the current state of loop power in error mode
ERROR_MODE Turns percent error mode on or off
ERROR_MODE? Returns whether percent error mode is on or off
ERROR_PORT Set the pressure port for percent error mode
ERROR_PORT? Returns the pressure port for percent error mode
FUNC Sets the display mode as specified in the command
FUNC? Returns the current mode of the upper, middle, and
lower display
HI_ERR Sets the 100% of span limit for percent error mode
HI_ERR? Returns the 100% of span limit for percent error mode
LOCAL Returns user to manual operation of the calibrator
LOCKOUT Locks out the keypad of the calibrator in remote opera-
tion
LO_ERR Sets the 0% of span limit for percent error mode
LO_ERR Returns the 0% of span limit for percent error mode
PRES_UNIT Set the pressure unit for the indicated display
PRES_UNIT? Returns the pressure from the indicated display
REMOTE Puts the calibrator in remote mode
27