Filter
Top Products
5. If you’ve located a setup code that works,
but it also has a separate VCR code,you’ll
also need to program it into the remote
control to access VCR controls as follows:
a. Press
VCR once.Then press and hold
the
SET key until the LED blinks twice.
b. Enter the VCR code for your DVD
Player/VCR Combo.If correct,the
LED
will blink twice.
NOTE:If a separate VCR setup code is not listed,
you can use the VCR key to program a separate
VCR device or another device (see “Re-Assigning
Device Keys”on page 15)
6. For future reference,write down the
working DVD Player/VCR combo code in
the below boxes:
DVD/VCR Code:
VCR Code:
(if used)
SEARCHING FOR YOUR CODE
If your device does not respond to the remote control
after trying all codes listed for your brand,or if your
brand is not listed at all,try searching for your code.
For example,to search for a code for your TV:
1. On the remote control,press
TV once.
2. Press and hold SET until the LED (red light)
blinks twice,then release
SET.
3. Enter 9 - 9 - 1.The LED will blink twice.
4. Aim the remote control at the the TV and
slowly alternate between pressing POWER
and TV. Stop when the TV turns off.
NOTE:In the search mode,the remote control
will send IR codes from its library to the selected
device,starting with the most popular code first.
5. To lock in the code,press and release SET.
The
LED will blink twice.
6. To search for the codes of your other
devices,repeat steps 1 through 5,but
substitute the appropriate device key for
the device you are searching for.
11
OFA 6 PVR 2/15/03 9:25 AM Page 11