Filter
Top Products
USING KEYMOVER
The One For All 6-Device PVR Universal Remote
Control includes a Keymover feature that allows you to
map (or copy) keys from one mode (i.e.,source mode)
to another mode (i.e., destination mode).
NOTE:The following keys cannot be used as a source or
destination: TV,PVR,DVD,CBL/SAT,AUD,VCR,and SET.
Programming Keymover
For example,if your VCR does not have volume control,
you can map those keys (i.e.,
VOL+,VOL-,and Mute)
from the TV mode to the VCR mode as follows:
1. Press and hold
SET until the LED (red light)
blinks twice,then release
SET.
2. Enter 9 - 9 - 4.The LED will blink twice.
3. For the source mode,press
TV once.
4. For the source key,press VOL+ once.
5. For the destination mode, press
VCR once.
6. For the destination key,press
VOL+ once.
7. The LED will blink twice indicating the
keymoved sequence is correct.
8. Repeat steps 1 through 7 twice more to
map remaining volume control keys,
substituting
VOL- and Mute as source and
destination keys in steps 4 and 6.
Upon completion of the above procedure,you can now
use your One For All 6-Device PVR Universal Remote
Control to control the TV’s volume and mute in the
VCR mode,as well as in the TV mode.
Restoring Keymoved Keys to Default Settings
Restoring A Single Keymoved Key
1. Press a device key that has a keymoved key.
2. Press and hold
SET until the LED (red light)
blinks twice,then release
SET.
3. Enter 9 - 9 - 4.The LED will blink twice.
4. Press the destination key twice (where the
keymoved key is stored).The
LED will
blink twice.
14
OFA 6 PVR 2/15/03 9:25 AM Page 14