Filter
Top Products
CHECKING THE CODES
If you have set up the remote control using the
Searching For Your Code procedure (on the previous
page),you may need to find out which four-digit code
is operating your equipment.
For example,to find out which code is operating your TV:
1. On the remote control,press
TV once.
2. Press and hold SET until the LED (red light)
blinks twice,then release
SET.
3. Enter 9 - 9 - 0.The LED will blink twice.
4. To view the code for the first digit,press
1
once.Wait 3 seconds,count the LED
blinks (e.g.,three blinks = 3) and write
down the number in the leftmost box in
the TV code boxes on page 10
NOTE:If a code digit is “0”, the LED will not
blink.
5. Repeat step 4 three more times for
remaining digits.Use
2 for the second
digit,
3 for the third digit,and 4 for the
fourth digit. Write down the code digits in
the remaining TV code boxes on page 10.
6. To check for codes of other devices,repeat
steps 1 through 5,but substitute the
appropriate device key for each device you
are checking.Write down the device’s code
digits in the appropriate code boxes on
page 10.
PROGRAMMING MASTER POWER
In its default state,the POWER key on the URC-6131
remote control will individually power your home
entertainment devices on or off.However, you can also
program a Master Power function onto the
POWER key
that will sequentially turn on or off all the devices with
a single key press.
Programming The Power Key For Master Power
1. Press and hold SET until the LED (red light)
blinks twice,then release
SET.
12
OFA 6 PVR 2/15/03 9:25 AM Page 12