Filter
Top Products
17
Connecting the POWER
The DV-CP500 is shipped with the main power (POWER) switch in the
on position (
ON). When the power cord is plugged in for the first
time, the DV-CP500 will automatically enter the standby mode and the
STANDBY indicator will blink for about 10 seconds, then light (same
condition after step 2 below). While the STANDBY indicator is
blinking, operation buttons will not function.
Turning on
2 Press POWER to switch on
the main power.
The DVD Changer enters standby mode.
The STANDBY indicator blinks for about 10 seconds, then
lights. While the STANDBY indicator is blinking, operation
buttons will not function.
Notes
• The buttons on the remote controller do not operate if the
POWER switch is set to OFF.
• To switch off the main power, press POWER again.
3 Press STANDBY/ON on
the DVD Changer or remote
controller.
The DVD Changer turns on and the STANDBY indicator
turns off. It takes several seconds to read the disc in the disc
tray.
Notes
•
You can turn on the DVD Changer by pressing 0 or £/8.
•
To put the DVD Changer in the standby mode, press STANDBY/
ON on the DVD Changer, or remote controller. Be sure to set the
volume to minimum before putting the DVD Changer in the
standby mode for the next use to avoid sudden loud sound
reproduction.
•
While the STANDBY indicator lights up, the DVD Changer can
receive signals from the remote controller. However, if you press
POWER on the DVD Changer to switch off the main power, the
remote controller cannot be used to turn on the DVD Changer.
• Setting the STANDBY button to standby does not shut off the
power completely.
Notes
• Make sure that all appropriate connections have been completed as
described on pages 14 to 16.
• Turning on the DVD Changer may cause a momentary power
surge, which might interfere with other electrical equipment such
as computers. To prevent interference, use a wall outlet on a
different circuit.
STANDBY/ON
POWER STANDBY/ON
STANDBY indicator
1 Plug the power cord into the
power outlet on the wall.