Onkyo DV-L55 DVD Player User Manual


 
17
Connecting the DV-L55
—Continued
The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In
this setup, stereo audio is played through the speakers in your TV.
This player is equipped with copy protection technol-
ogy. Do not connect this player to your TV via a VCR
using AV cables, as the picture from this player will
not appear properly on your TV. (This player may also
not be compatible with some combination TV/VCRs
for the same reason; refer to the manufacturer for more
information.)
When connecting to your TV as shown above, do not
set the “Component Out” setting (page 41) to “Pro-
gressive.”
1. Connect the VIDEO OUTPUT and AUDIO OUT-
PUT ANALOG L/R jacks to a set of A/V inputs
on your TV.
Use the supplied AV cable (RCA/phono), connecting
the red and white plugs to the audio outputs and the
yellow plug to the video output. Make sure you
match up the left and right audio outputs with their
corresponding inputs for correct stereo sound.
See the following page if you want to use a compo-
nent or S-Video cable for the video connection.
2. Connect the supplied AC power cord to the AC
INLET, then plug into a power outlet.
Notes:
Before unplugging the player from the power outlet,
make sure you first switch it into standby using either
the front panel STANDBY/ON button, or the remote
controller, and wait of the “GOOD BYE” message to
disappear from the player’s display.
•For the above reasons, do not plug this player into a
switched power supply found on some amplifiers and
AV receivers.
Important:
When Component Out (page 41) is set to Progressive,
there is no video output from the VIDEO OUTPUT
(composite) and S VIDEO OUTPUT jacks.
If you want to display video on more than one monitor
simultaneously, make sure the player is set to Inter-
lace.
If you connect a TV that is not compatible with a pro-
gressive scan signal and switch the player to progres-
sive, you will not be able to see any picture at all. In
this case, switch everything off and reconnect using
the supplied video cable, then switch back to Interlace
(see page 18).
Basic Setup
AUDIO OUTPUT
OPTICAL COAXIAL
DIGITAL COMPONENT
AUDIO
OUTPUT
ANALOG
VIDEO OUTPUT
S VIDEO VIDEO
R
L
YPB
PR
REMOTE
CONTROL
AV CONNECTOR
AC INLET
L
R
ANALOG
INPUT
VIDEO IN
To power outlet
TV
DV-L55_En.book Page 17 Friday, May 28, 2004 12:02PM