Filter
Top Products
20
Connecting the Power/Turning on the DVD player
Before connecting
• Make sure that all the connections on pages 15–19 are complete (the connection to a TV is required).
If you experience picture distortion with some discs, or a picture is black, set the TV system to match your country or
region’s system.
Notes:
• Settings changed while the unit is On are saved to
memory when the unit is set to Standby. If the unit’s
power cord is unplugged while the unit is still On, any
changed settings will not be saved. Be aware of this
when the unit is connected to a switched AC outlet on
another component.
• While a disc is loaded, the TV system cannot be
switched. Unload a disc to switch the TV system.
ON/STANDBY
ENTER
TOP MENU
ON/STANDBY
ON/STANDBY
OPEN/CLOSE
RECEIVER
INPUT
VOL
CLEAR
MUTING
MENU
ON/STANDBY
1
Connect the power cord into the power outlet on the wall.
2
Press ON/STANDBY on the DVD player or ON/STANDBY on the remote controller.
The DVD Player turns on.
•To put the DVD player in the standby mode, press ON/STANDBY on the DVD player, or ON/
STANDBY on the remote controller. Be sure to set the volume to minimum before putting the
DVD player in the standby mode for the next use to avoid sudden loud sound reproduction.
• Setting the ON/STANDBY to standby does not shut off the power completely.
• The DVD player will turn on automatically if the OPEN/CLOSE or
[] (
Play) on the remote
controller is pressed while the unit is on Standby.
Setting the TV system (Not North American model)
Remote
controller
ON/STANDBY
With no disc loaded, press [ ]
(Pause) for 5 seconds to switch
between PAL and NTSC.
Remote
controller