Filter
Top Products
10
Connecting the DV-C501 to a TV
Here is how to connect your DVD Changer to your TV set. In this case, both the video and audio signals will be played back by
your TV set.
Connecting the DV-C501 to a TV
1. Switch off the DVD Changer and the TV set.
2. Connect the DV-C501 to your TV set as shown in the illustration.
■ Selecting the audio outputs
Your DV-C501 provides several options for audio playback: you can use the analog or one of the digital audio outputs. If the
audio is to be played back by your TV set, connect the ANALOG OUTPUTs to the audio inputs of your TV set and activate them
(“Analog 2ch”). See “Audio Settings” on page 36 for details.
Notes:
• See also the instruction manual of the connected TV on how to select the signals transmitted by the DVD Changer.
• Before connecting the DVD Changer to your TV, be sure to turn off the power to and unplug both units from the wall outlet.
• If your TV set has one audio input (monaural), connect a Y cable adapter to the DV-C501’s ANALOG OUTPUTs, and the other end of the
adapter to the TV’s audio input.
• Be sure to establish a direct video connection between the DV-C501 and your TV set. Do not route the video signal through your VCR or other
video component. Otherwise the picture may be distorted due to the DVD disc’s copy protection.
Connecting a power cable
1. Connect the outlet plug on the included power cable to the
AC INLET on the DV-C501.
2. Plug-in the other end of the cable to a wall AC outlet.
Notes:
• Do not use any power cable other than the included cable. The
included cable is designed for use only with the DV-C501. Do not
use it for any other device.
• Do not connect or disconnect the outlet plug from the DV-C501
while the other end is plugged into the wall AC outlet.
R
L
COMPONENT
Y
P
B
P
R
VIDEO
S VIDEO
OPTICAL
COAXIAL
DIGITAL
OUTPUT
VIDEO OUTPUT
ANALOG
OUTPUT
AC INLET
2
1
R
L
COMPONENT
Y
P
B
P
R
VIDEO
S VIDEO
OPTICAL
COAXIAL
DIGITAL
OUTPUT
VIDEO OUTPUT
ANALOG
OUTPUT
AC INLET
Do not plug in the
power cable until
all connections
have been made.
Signal flow
To ANALOG
AUDIO OUT
To audio inputs
(white)
(red)
Audio·video cable (supplied)
To
VIDEO
OUT
To S VIDEO OUT
S video cable (supplied)
If the TV has an S video input, connect the
DVD Changer with the supplied S video cable.
To S video input
TV or monitor with
audio and video inputs
(red)
(yellow)
To video input
(yellow)
Power cable
(included)
To wall outlet
(white)
(see below)
Improper connection
Insert completely